[6bone] Cisco bug ?

[Hans Goes]

Hi,

We're using a Cisco 7507 with a RSP4+ (256meg).

6B1.AMS7#ping 2001:820:0:1:1::2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:820:0:1:1::2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 40/64/100 ms
6B1.AMS7#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
6B1.AMS7(config)#router bgp 1890
6B1.AMS7(config-router)#neighbor 2001:820:0:1:1::2 remote-as 16186
6B1.AMS7(config-router)#address-family ipv6
6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 activate
6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 peer-group transit
% Activate the peer-group for the address family first

6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 remote-as 16186
6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 peer-group transit
% Activate the peer-group for the address family first

6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 activate
6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 remote-as 16186
6B1.AMS7(config-router-af)#neighbor 2001:820:0:1:1::2 peer-group transit
% Activate the peer-group for the address family first

Any idea ? I've had this problem a couple of times but still the same
problem. Sometimes a router reload helps... But that's not the way we want
it :)

System image file is "slot0:rsp-pv-mz.122-0.5.T.bin"


Hans

WorldCom
EMEA Network Operations
Joan Muyskenweg 24
1096 CJ Amsterdam

Tel: +31 20 7112428 (Fax: 2455)
V-Net: 711 2428
http://www.wcom.com/nl/