Cisco tunnel config

[Hossam El-Ashkar]

> I have downloaded your ios image for 1600 routers. There is a
> command for the configured tunnel " tunnel mode ipv6ip " in the
interface
> conf mode. It does not work, the ios does not recognize this command!!!
> How can i configure a tunnel??

you are trying this with a tunnel interface?
A typical tunnel configuration would look something like this:
interface Tunnel0
 no ip address
 ipv6 unnumbered Ethernet0
 tunnel source Ethernet0
 tunnel destination 130.67.0.1
 tunnel mode ipv6ip
!

If this doesn't work can you please send us the output of sh ver and sh
conf?

Thanks,
Ole                                         

On Mon, 22 Feb 1999, Vitaly Chipitsyn wrote:

> Hello, everyone.
> 
> It is me (with my cisco) again. ;)
> I have found IOS 11.3/IPv6 for Series 2501, and my present problem is
> that I cannot find a proper way to configure tunnel to our
> pTLA. Those of you who use ciscos, could you send me any hints? 
> 
> Sections of your `show running-config` as examples will be very helpful.
> 
> There is a command 'show ipv6 tunnel', but there is no command (none
> that I could find) under configure-mode that I can use to actually
> _configure_ a tunnel.
> 
> Generally, is there any documentation available that covers IPv6 part
> of Cisco's IOS? I will look for it at www.cisco.com as a CCO-member,
> so I am basicly asking about documentation other than from Cisco.
> 
> Thanks.
> --vc
> 

--------------------------------------------------------------
Hossam El-Ashkar
IDSC/RITSEC - Communication Dept.
hoashkar@idsc1.gov.eg