BGP4+configuration on Cisco routers

[Jan Marius Evang]

WE are trying to set up BGP4+ routing to 6bone through SICS, and there
seems to be something wrong in the way we do it... There is not much
help from the Cisco web-page, or from the router command-line.

Has anybody got any hints?

Yours
Jan Marius Evang

from show running-config:

ipv6 bgp neighbor 3FFE:200:1:B::1 remote-as 2839
ipv6 bgp neighbor 3FFE:200:1:B::1 ebgp-multihop 3
ipv6 bgp network 3FFE:2A00::0/24 summary
interface Tunnel0
 no ip address
 ip route-cache policy
 ipv6 enable
 ipv6 address 3FFE:200:1:B::2/64
 tunnel source 128.39.11.253
 tunnel destination 193.10.66.219
 tunnel mode ipv6ip
autonomous-system 224
ipv6 route 3FFE::0/16 3FFE:200:1:B::1

#sh ipv6 bgp
BGP IPv6 table version is 0, local router id is 0.0.0.0
Status codes: * - valid, > - best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete

#sh ipv6 bgp ne
 
BGP neighbor 3FFE:200:1:B::1, remote as 2839, internal link
  local address 0::0, version 0

#sh ipv6 bgp su
BGP table version 0, IPv6 routing table version 0
 
Neighbor                                     TblVer Peer Connection
3FFE:200:1:B::1                                   0 ibgp   multihop


-- 
-O         /\/\ |  Jan Marius Evang  | 
Røyskatt   0 0 \|    Greve av Ling   | "En krakk er en Røyskatt"
           \ /\ | /In Aurum Veritas/ | [Bare Egil Band, "Alle dyr"]