Build a tunnel between telebit router and zebra routing daemon

[Wilfried Woeber, UniVie/ACOnet]

=> We use Telebit router to build tunnel with zebra routing daemon.
=> The tunnel seems connected (we use ping ,traceroute debugging tool
=> can ping IPv4 , IPv6 the end point of  tunnel  ),but BGP4+(rfc2283)
=> routing protocol can not work correctly?
=
=You may want to email the zebra folks about this as well.....

  ...and you may want to add a few more technical details about 
  your environment, like software versions, link type(s), and the like 
  and what the symptoms of "can not work correctly" are.
  
  While we were testing interoperability for BGP4+ and RIPng "recently"
  (both router- and host-based), we ran into a few hickups with getting
  telebit, cisco and MRTd to talk to each other.  Some of the problems
  were related to particular interface types (like BGP4+ was ok on
  Ethernet but did not work over ATM).
  All of those problems were properly resolved.
  
  -WW
 --------------------------------------------------------------------------
  Wilfried Woeber                :  e-mail: Woeber@CC.UniVie.ac.at
  Computer Center - ACOnet       :  Tel: +43 1 4277 - 140 33
  Vienna University              :  Fax: +43 1 4277 - 9 140
  Universitaetsstrasse 7         :  RIPE-DB Handle: WW144
  A-1010 Vienna, Austria, Europe :  PGP public key ID 0xF0ACB369
 __________________________________________________________________________